Place the topside controller in the place of the previous one. Remove the plastic from the self-stick backing of the topside controller. Remove the spa access panel and take the cover off of the control box and unplug the wire that goes form the topside panel to the circuit board. Replacing a topside control panel is a fairly simple process. Otherwise, get the number for your spa control pack and call the manufacturer to find out which top side panel will work for you. A sticker is typically on the side indicating a part number from the manufacturer.
There is often a part number on the existing top side panel when you pull it out of the housing. Before you purchase a new panel, make sure it’s compatible with your existing spa control pack. If you need to replace the control panel altogether, there are a few things you should know beforehand. Replacing the Hot Tub Topside Control Panel Your unit may not have sufficient voltage to support the topside panel you have purchased. If your readout panel is flickering, check to make sure you have low voltage problems.The backlights may be burned out on your panel and may need to be replaced.Remove the panel, clean everything carefully, then plug the topside back in. Dirt, rust, or moisture will cause issues with your panel’s readout. If not, check your transformer and circuit board. If the new topside works, replace the old unit. If you buy a replacement, plug it in to double check that the problem is corrected by a new unit. Be sure the incoming power is coming from where it should. There’s a chance the unit isn’t getting any power.A dent made by a pinch during installation or an older wire that has been gnawed on may render the topside panel defective. Check the entire length of the unit’s wire to check for damage. The wire connecting the panel could be the issue.Make sure the one you’ve purchased as a replacement is compatible with your unit. You may have selected the wrong panel.Check your connections to make sure that it’s secure and tight. Your control panel may not be plugged in.My Unit Has no Message or Doesn’t Light Up.If you have some other issues with your hot tub topside control panel, here are some other possible ways to troubleshoot the problem. Test your sensors to make sure everything is working properly. Once it has regulated, you should be able to reset the system by pushing any button. Open the cover and let the water cool off. DO NOT enter the water because it may have reached unsafe temperatures. HH, HTR TEMP LMT, OH, or OHH-Any of these messages might mean your spa has overheated.This is an excellent time to bring in a technician. GFI or GFCI failure-This could mean your hot tub could not trip the GFCI breaker and continued operation may be unsafe.
#Hot tub topside control panel manual#
Check your owner’s manual for a complete list of error messages. It could alert you that it’s time for a new hot tub filter, heater issues, or various other maintenance concerns. Messages appear on the hot tub topside control panel when the unit needs to communicate something. Hot tubs that come with an LCD display give users the added benefit of getting specific error messages when something goes wrong with the spa equipment.
0 kommentar(er)
